16" Fretboard Router Radiusing Bit
Custom made Fretboard/Fingerboard Radiusing Router Bit
Fed up with the laborious slow job of radius block and sand paper to radius a Fretboard?
Using these router bits you can radius a fretboard/fingerboard in seconds!
The carbide tips are the extra hard a fine K01 carbide specifically for use with extra hard woods used for fretboard/Fingerboard - such as rosewood or ebony.
The bits are precision machined to provide an incredibly accurate radius.
The radius cutting section of the bit is 50mm (~2") so you can radius a 100mm (~4") wide blank without an issue.
The shaft is 1/2" (12.7mm) - they are not available with 1/4" shafts.